Technical Data Sheet
SEC-MM-0613
Roll Size
150x330mm
Type of Construction
Monoblock Single Bed
Rolls
Chilled cast iron rolls, mirror finish chill depth 10to12mm hardness : 68 to 70 r.c working face
Roll Nip Gap
0 to 10 mm for working (30 mm for roll cleaning)
Batch Capacity
7.5-10 kgs per batch depending up on the hardness of the compound
Roll Speed Std RPM (Surface Speed & Friction ration can vary as per request)
Rear roll : 15.5 rpm Front roll : 13 rpm
Roll Colling
Spray Pipe with bell mouth
Stock Guide
Stock Guide on front & rear roll (lh & rh) with polymer liners & center tongues
Roll Safety
Shear Pad assembly will be provided with spacing button between the front bearing housing and main frame
Gross Weight
750kgs
Required Floor Space
1000x1800 mm
Friction Ratio std (Special on request)
1:1.2
Drive Motor-TEFC Squirrel cage (Std)
7.5 Hp/1500 rpm
Electrical Controls
All electrical and electronic controls will be standared 415V+10%, 3phase, 50Hz and control voltage will be 110V. AC/DC variable speed on request.
General Base
The mills are assembled with machined pads with drive unit safety pad
Bearing Housing & Reduction Gear
Bearing Housing assemblies with Pb 2 Brush. Helical Gear Reduction gear
Lubrication System
Oil cup lubrication system with gravity flow standard
